When your furnace stops working it may be a major problem that can only be attended to by professionals who do furnace repair in Des Plains, on the other hand it could very well be a simple fix, one that a homeowner can do independently. These are the types of little fixes that can easily save the cost of a call-out. Furnace repair professionals will tell you that perhaps 25 percent of the callouts they get could have been avoided if their customer was aware of these few simple fixes.
- Check the thermostat: The first thing to look into is the thermostat; make sure it is actually signaling the furnace to turn on. Some of the modern programmable thermostats can be quite complicated and it seems that the more options that are available, the more that go wrong.
- First make sure that the thermostat id set to “heat” and not “cool.” Compare the temperature of the room to the temperature setting, set the temperature setting five degrees or so higher than the room temperature and see if the furnace kicks in. Check the battery, if there has been a power outage and the battery is dead the thermostat will have reverted to its factory settings.
- Check the breaker: Check the actual on-off switch; it is usually mounted close to the furnace. If the switch is on then check the circuit breaker in the panel.
- Change the filter: A dirty filter can cause the furnace to shut down. If the filter is clogged it is possible that the heat exchanger will overheat and shut off to soon, the result is a house that will not get warm enough. If you hear the blower running but the furnace is not giving out warm air, replace the filter.
- Check the fuel supply: if the main switch can be accidently turned off so can the gas supply. Check it, if you have a dated furnace check the pilot light as well.
- Check to ensure the chimney flue is clear: During the summer months it is not unusually for birds to nest in a chimney flue. Open the duct that exits the furnace and look for debris or other evidence of a blockage.
- Flush drain lines: Modern high-efficiency furnaces can take off several gallons of water a day when the furnace is running. If this line becomes blocked, and mold can do this, remove the line and flush it with a mixture of bleach and water.
Hopefully these tips will lead to an elimination of the problem, if not then the solution is to call professionals who do furnace repair in Des Plains. Browse the site website domain for more information.
